Drywall has established itself as a staple of American home construction, replacing plaster and often going by other names, such as sheet rock. However, sometimes drywall suffers damage, such as from water, and repairs or replacement will be necessary, either by hiring a contractor or doing home repairs. Different tools and features, from fastener screws to an access panel to staple guns to no coat drywall tape will make any repair job easier for a homeowner or contractor.

Keeping a Home Insulated

Insulation is critical for a house’s energy efficiency, comfort, and more. Although a person can save up to 10% in energy costs every year by adjusting the thermostat down 7 to 10 degrees, having proper drywall installation and other insulation like spray foam insulation really keeps a house efficient. Four general types of insulation can be found: rolls and batts, rigid foam, loose-fill, and foam-in-place. After all, the average home uses up to 50% of its energy on heating and cooling, and if damaged drywall or foam allows heat or cold to leak out, the HVAC system has to do a lot of extra work to regulate climate control. Often, ceilings and the roof are targets for insulation repair, since heat can easily rise and escape the home in winter, or cold can seep out during summer through the walls. Good maintenance of drywall, such as with caulk, foam sealant, and no coat drywall tape can keep a house up to date on repairs.

Work and its Costs

When repairing or replacing drywall or parts of the roof, a person can use tools for at home repair, or hire a contractor to do the job, depending on budget and personal expertise. Homeowners should note that on average in the United States, roof repair costs can be $773, although it is also common for spending to range anywhere from $355 to $1,229. Smaller roof repair jobs can cost between $150 and $400, as well as labor costs ranging from $45 to $75. Or, if the homeowner has the expertise and tools, repair can be done alone.

Supplies for drywall installation or repair can include tape guns, work gloves, no coat drywall tape, drywall brackets, and spray foam kits. No coat drywall tape can be essential to finishing a job and making sure that there are no leaks present. And according to HandyMan How To, someone performing repairs should be aware of what is on the other side of water damaged drywall, such as heating and cooling vents, plumbing, electrical wires, or metal support runners. An inspection hole can be cut, and a flashlight and small mirror can be used to see what is on the wall’s other side.

Sometimes, drywall must be replaced if it is heavily water damaged, and in this case, cutting a section out five inches square can help, and a brand new sheet of drywall can be put into place, then glued and jointed securely, and no coat drywall tape can help finish the job. But if a leaky pipe or other hazard may damage the wall again in the future, installing an access panel can help any homeowner reach pipes when they become leaky so the drywall does not have to be repaired so often. A professional contractor can do this, too, and install a chosen brand of drywall access panel.

Leave a Reply